User Tools

Site Tools


User's Manual & Quick Start Guide


Where to Purchase

Donations & Support

Replacements Parts & Information

Mods & Improvements



Slicer Stuff




Web UI



Donations & Support

Looking for the Monoprice MP Mini Delta Wiki?


This is an old revision of the document!

Extended G-code Table

Standard Marlin compatible G-codes can be found at the RepRap wiki: G-code.
Not all standard G-code are supported by the MP Select Mini.

Command Description
M550 Get/Set SSID
M551 Get/Set Password
M552 Display IP address
M555 P1 Reset WiFi interface (Seems to reboot printer)
M556 Display network status
M560 Update firmware using update.bin in microSD card
M561 Change thermistor type
M562 Invert stepper motor direction
M563 Enable fast mode for web uploading
M564 address_without_http HTTP Download (Unsure how to use)
M565 Print cached file cache.gc
M566 Rename cache.gc

*Some of the above commands may not work with firmware versions 22.39 & older. They have been implemented in 26.42 & higher.

Example Uses

M550 & M551 - Connect to WiFi

M550 SSID             ;SSID = Name of WiFi network (case sensitive)
M551 PASSWORD         ;PASSWORD = Password for WiFi network (case sensitive)

M561 - Change thermistor type

M561 P1               ;Change to 104GT
M500                  ;Save EEPROM
Reboot printer to complete the process
M561 P0               ;Change to original/stock
M500                  ;Save EEPROM
Reboot printer to complete the process

M562 - Invert Stepper Motor Direction

M562 E                ;Inverts extruder motor direction
M500                  ;Saves changes to EEPROM
Reboot printer to complete the process

M563 - Enable fast mode for web uploading

M563 S6               ;S value can be 2-6

M566 - Rename cache file

M21                   ;Initialize SD card 
M20                   ;List SD card 
M566 new_file_name.gc ;renames cache.gc to a user given file name
M20                   ;List SD card (to verify file was renamed)
extended_g-code_table.1474702080.txt.gz · Last modified: 2016/09/24 07:28 by Matthew Upp