extruder_calibration
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
extruder_calibration [2018/01/02 06:36] Matthew Upp |
extruder_calibration [2018/01/03 22:56] (current) Matthew Upp |
||
|---|---|---|---|
| Line 24: | Line 24: | ||
| ==== View current values ==== | ==== View current values ==== | ||
| - | - Send command "M503" ([[g-code#sending_g-code|Sending G-code]]) | + | - Send command "M503" ([[g-code#sending_g-code|Sending G-code]]) \\ |
| + | * <wrap lo>//(USB only for most V2's. Some early V2's and V1's should be able to receive response via WiFi also.)//</wrap> | ||
| - Look for: | - Look for: | ||
| * "Steps per unit:" | * "Steps per unit:" | ||
extruder_calibration.txt · Last modified: 2018/01/03 22:56 by Matthew Upp
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
