User Tools

Site Tools


firmware:motion_controller

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
firmware:motion_controller [2020/06/30 23:24]
Matthew Upp
firmware:motion_controller [2020/10/03 00:14] (current)
Matthew Upp
Line 171: Line 171:
 */ */
  
 +<WRAP group>
 +<WRAP column half>
  
-YouTube link:  https://​youtu.be/​zAj9wqvPNfA ​- Updating motion controller firmware - The method shown in the video is a different method of the update process.+<wrap em>This video is for the MP Mini Delta but the steps are the same as outlined above.</​wrap>​ 
 +{{youtube>​xYYFIkEVk28?​medium}} 
 +**Updating Monoprice MP Mini Delta Motion Controller Firmware** \\ 
 +A much longer than necessary video but it shows the complete steps needed to successfully update the Motion Controller firmware using the included microSD card. Other microSD cards (but not all) can also work but may not need to be formatted or may need to be formatted using a different file system and block size combination. \\ 
 +YouTube link: https://​youtu.be/​zAj9wqvPNfA
  
 +</​WRAP>​
  
-{{youtube>​zAj9wqvPNfA?​large}}+<WRAP column half> 
 + 
 +<wrap em>​Alternative (not recommended) method for updating motion controller firmware.</​wrap>​ 
 +{{youtube>​zAj9wqvPNfA?​medium}} 
 +**Updating Motion Controller Firmware - Monoprice MP Select Mini V1 3D Printer** \\ 
 +The method shown in the video is a different method of the updating the motion controller firmware than outlined in the instructions above. The instructions outlined above or in the video for the Mini Delta should be used as opposed to the YouTube video from June 15, 2016 that was meant for the Select Mini V1. Choosing the firmware update file from the "​Print"​ menu is more likely to fail and possibly soft-brick the printer which will then require using the method outlined above anyways. The Select Mini V2 seems to have more problems than the V1 when updating the motion controller firmware using the print menu. \\ 
 +YouTube link: https://​youtu.be/​zAj9wqvPNfA 
 + 
 + 
 +</​WRAP>​ 
 +</​WRAP>​
firmware/motion_controller.txt · Last modified: 2020/10/03 00:14 by Matthew Upp