This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
firmware:motion_controller [2019/09/28 10:40] Matthew Upp |
firmware:motion_controller [2020/10/03 00:14] Matthew Upp |
||
---|---|---|---|
Line 12: | Line 12: | ||
==== V2 Owners Please Read Before Updating ==== | ==== V2 Owners Please Read Before Updating ==== | ||
* If your V2 currently has Motion Controller v34 or higher installed then you can update to v41 firmware. \\ | * If your V2 currently has Motion Controller v34 or higher installed then you can update to v41 firmware. \\ | ||
- | * If your V2 currently has Motion Controller v30 do NOT attempt to update to v41 firmware. \\ | + | * If your V2 currently has Motion Controller v30 or lower do NOT attempt to update to v41 firmware. \\ |
- | * If your V2 currently has Motion Controller versions 31, 32, or 33 please ask before updating with this firmware. \\ | + | * If your V2 currently has Motion Controller versions 31, 32, or 33 please ask before updating with this firmware. You may be able to update to v40 or v41 but I haven' |
* Do NOT rename <color # | * Do NOT rename <color # | ||
</ | </ | ||
Line 171: | Line 171: | ||
*/ | */ | ||
+ | <WRAP group> | ||
+ | <WRAP column half> | ||
- | YouTube link: https:// | + | <wrap em>This video is for the MP Mini Delta but the steps are the same as outlined above.</ |
+ | {{youtube> | ||
+ | **Updating Monoprice MP Mini Delta Motion Controller Firmware** \\ | ||
+ | A much longer than necessary video but it shows the complete steps needed to successfully update the Motion Controller firmware using the included microSD card. Other microSD cards (but not all) can also work but may not need to be formatted or may need to be formatted using a different file system and block size combination. \\ | ||
+ | YouTube link: https:// | ||
+ | </ | ||
- | {{youtube> | + | <WRAP column half> |
+ | |||
+ | <wrap em> | ||
+ | {{youtube> | ||
+ | **Updating Motion Controller Firmware - Monoprice MP Select Mini V1 3D Printer** \\ | ||
+ | The method shown in the video is a different method of the updating the motion controller firmware than outlined in the instructions above. The instructions outlined above or in the video for the Mini Delta should be used as opposed to the YouTube video from June 15, 2016 that was meant for the Select Mini V1. Choosing the firmware update file from the " | ||
+ | YouTube link: https:// | ||
+ | |||
+ | |||
+ | </ | ||
+ | </ |