User Tools

Site Tools


Sidebar


User's Manual & Quick Start Guide

Specifications

Where to Purchase

Donations & Support

Replacements Parts & Information

Mods & Improvements

How-to

OctoPrint

Slicer Stuff

Troubleshooting

Maintenance

WiFi

Web UI

Firmware

Downloads

Donations & Support


Amazon Affiliate Program Disclosure

Looking for the Monoprice MP Mini Delta Wiki?

firmware:motion_controller_recovery

This is an old revision of the document!


Recovery Mode - Motion Controller

The recovery mode method can be used as follows:

  1. Copy any version “update.bin” firmware file from the firmware folder to the SD card.
  2. Create an empty file named “fcupdate.flg” and copy to the SD card.
  3. Power on the printer. When the printer is powered on, it will force the update.
  4. IMPORTANT: After successfully updating, remove the SD Card and delete the “fcupdate.flg” file. You may also delete the “update.bin” file.
    (If recovering to a different version then follow the steps below)
  5. Export/Save any calibration you have done as the next step will erase/reset everything back to defaults.
  6. Reset EEPROM using “M502” and save EEPROM using “M500”
    Need help on how to send these commands? See Sending G-code
  7. (Optional) Run PID Autotune http://mpselectmini.com/pid_autotune

Trouble Recovering?

  • Format microSD card or use another microSD card and try again.
  • Verify the x-axis endstop is not pressed in.
firmware/motion_controller_recovery.1482693629.txt.gz · Last modified: 2016/12/25 19:20 by Matthew Upp