User Tools

Site Tools


howto:default_settings

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
howto:default_settings [2020/03/23 05:52]
Matthew Upp
howto:default_settings [2020/10/07 02:40] (current)
Matthew Upp
Line 61: Line 61:
  
 ===== Using gcode file ===== ===== Using gcode file =====
-<file gcode load_fw_defaults_and_save_to_eeprom.gcode>​+<code gcode load_fw_defaults_and_save_to_eeprom.gcode>​
 ; G-Code generated by Matthew Upp of GigDigit.com ; G-Code generated by Matthew Upp of GigDigit.com
 +; Revised 19:39 Tuesday, October 6, 2020
 ; ;
 ; Load firmware default settings and save to EEPROM ; Load firmware default settings and save to EEPROM
 ; ;
 ; This gcode file will work with the following 3D printers: ; This gcode file will work with the following 3D printers:
-; Malyan - M100, M200, M310, M300, M320, MA10, and MA10 Mini +; Malyan - M100, M200, M310, M300, M320, MA10, MA10 Mini 
-; Monoprice - MP10, MP10 Mini, MP Mini Delta, ​and MP Select Mini+; Monoprice - MP10, MP10 Mini, MP Mini Delta, MP Select Mini 
 +;
 ; ;
 ; This file is much longer than it needs to be but is like this to  ; This file is much longer than it needs to be but is like this to 
 ; show what is going on. ; show what is going on.
 ; ;
-; If when printing this file it does not show as completed on the +; Lines with only a semicolon are for making line separations only. 
 +
 +; If when "printing" ​this file it does not show as completed on the 
 ; display but the fan pulsed on and off a few times then the firmware ​ ; display but the fan pulsed on and off a few times then the firmware ​
 ; was set to default settings and you can turn the printer off and on  ; was set to default settings and you can turn the printer off and on 
 ; to make the new (default) settings active. ; to make the new (default) settings active.
-; 
-; Lines with only a semicolon are for making line separations only. 
-; Please add a blank line to the end of the file while editing. 
-; It is not a big deal if you don't add the blank line but the print  
-; completed screen will not appear and will require turning the  
-; printer off and back on to proceed. The default firmware settings  ​ 
-; will have been restored and saved either way. 
-; (DokuWiki Code Blocks deletes blank lines at the end of the block but  
-; g-code files typically end with a single blank line at the end.) 
 ; ;
 ; ;
Line 136: Line 131:
 M84 ; disable motors M84 ; disable motors
 ; END ; END
- +  
-</file>+</code>
  
howto/default_settings.1584942736.txt.gz · Last modified: 2020/03/23 05:52 by Matthew Upp