This is an old revision of the document!
“Extruder and hotbed are all 100K NTC resistor with beta 3950”
RioRand(TM) Upgraded 10 pcs 100Kohm NTC Thermistors thermistor,temperture sensor,Reprap,Prusa 3D printer
NOTE: Leads are not insultaed. You must insulate the leads before using.
Anycubic NTC 3950 100K Thermistor with 1 Meter Wiring and Female Pin Head for RepRap 3D Printer Bed or Hot End Pack of 5PCS
NOTE: The JST plug can be cut off. You may also choose to cut the wire closer to the thermistor to use the existing wiring.
2pcs M3 Screw on Modular Design NTC 3950 100k Thermistor with 1m Cable Wire
NOTE: The M3 stud screws into the heater block.
(These are only a couple that will work. This is not an exhaustive list.)