User Tools

Site Tools


Sidebar


User's Manual & Quick Start Guide

Specifications

Where to Purchase

Donations & Support

Replacements Parts & Information

Mods & Improvements

How-to

OctoPrint

Slicer Stuff

Troubleshooting

Maintenance

WiFi

Web UI

Firmware

Downloads

Donations & Support


Amazon Affiliate Program Disclosure

Looking for the Malyan M300 Mini Delta 3D Printer Site?

parts:thermistors

This is an old revision of the document!


Thermistor for M200 (Select Mini)

“Extruder and hotbed are all 100K NTC resistor with beta 3950”

Source: http://wiki.malyansys.com/doku.php?id=type_of_thermistors_of_m200

Replacements

RioRand(TM) Upgraded 10 pcs 100Kohm NTC Thermistors thermistor,temperture sensor,Reprap,Prusa 3D printer
Link: https://amzn.com/B00GD471PO
NOTE: Leads are not insultaed. You must insulate the leads before using.

Anycubic NTC 3950 100K Thermistor with 1 Meter Wiring and Female Pin Head for RepRap 3D Printer Bed or Hot End Pack of 5PCS
Link: https://amzn.com/B01B41K7OM
NOTE: The JST plug can be cut off. You may also choose to cut the wire closer to the thermistor to use the existing wiring.

2pcs M3 Screw on Modular Design NTC 3950 100k Thermistor with 1m Cable Wire
Link: https://amzn.com/B01BA8BNB0
NOTE: The M3 stud screws into the heater block.

(These are only a couple that will work. This is not an exhaustive list.)

parts/thermistors.1473708613.txt.gz · Last modified: 2016/09/12 19:30 by Matthew Upp